Water Heater Installation and Repair Tips
One of the best conveniences that came in as a result of modern technologies to the people is creation of the water heater. What could possibly be more comforting than a warm water shower or bath on a chilly morning to awaken a sleepy body and mind. It also assists in cleaning your skin by removing excess oil and dirt. Due to the advantages that it provides, for generations people are willing to devote their hard earned cash to have a water heater set in their residence.
Here are some tips to have the right kind of water heater installation as well as repair in case you need these services someday. When installing a new water heater, first you have to pick the most suitable one for you. Water heaters may use either electricity or gas. Sometimes a gas water heater may be cheaper to operate than electric but it is going to vary by area. However, if your home does not have gas service to it, then the only sensible choice is electrical.
Check the pipes by measuring the hot and cold water pipes which presently exist in the home and ensure that your new heater would be the proper match. Based on the age of the home, you might have to purchase a some couplers to make the pipes fit properly.
Before you can do anything, make certain to turn off most of the utilities connected to that unit whether it’s electric or gas. Once turned off, you can now drain the hot water tank and disconnect the old cold and hot water pipe connections. To drain the water out of the tank, you need to connect a hose to the outlet of the tank and then drain the water outside.
When the old device is totally drained of water and efficiently disconnected, you can then remove it to make space for the new unit. The next thing is to put in any fittings to the unit such as the pressure and temperature relief valve if they’re not installed. Then join the water lines and make sure to use appropriate procedures so that you do not get leaks when you fill the new tank. You are able to connect to the power supply now, either gas or electric. If you are using a gas line then you will need to join the flue port to make sure fumes are correctly removed from the house. After all the connections are in place, you can now fill out the water heater with cold water and turn t on the new unit.
It is advisable to insulate your water heater tank by means of a water heater blanket. This measure can reduce the costs of to maintain the water hot when you want it.
You can set up a new unit by yourself but using the services of a plumbing expert is mostly the best choice to save you money and time in the long run unless you have enough plumbing experience.